Advertisement
High Frame Installation 2 WD & 4 WD
Frame Rail Pre-Assembly: (continued)
High Frame Mounting Tube Components. (See Figure 4) These Components are Sitting in
approx. position of assembly to illustrate where they are to be when tack welding them. Space is left
between them for Illustration only, they will be closer together when assembled.
Also See Figure 3 on previous Page.
Angle Mount (2
each side)
Frame
Rail
Rear of
Frame Rail
Bar Mounting
Strap Cut Off
(2 each side)
Figure 4
High Frame and King Post Frame Sub-Assembly. (See Figure 5) The High frame will come
with the King Post Sub-Assembly Bolted to it. The King Post Sub-Assembly bolts to High Frame; these
Bolts must torque to 375 ft. lbs. These should be Torqued when received from the factory. The Lift
Cylinder will not be assembled to King Post; it is shown in figure 5 for Illustration and will have to be
mounted later after final installation of High Frame. The 2 Wheel drive and 4 Wheel Drive High frames
are different and will not interchange In Figure 5 the 2 Wheel drive High frame is shown, the 4 Wheel
drive High Frame has the King Post Mounting plate welded higher up on frame than shown here. DO
NOT try to use a 2 Wheel drive Frame on 4 Wheel Drive Tractor or vice versa, it will not work.
Machete (JD-62, 63, 6420 Asy Man) 10/04
© 2004 Alamo Group Inc.
Locknuts (3 each side)
Section 4 - 6
Bolts (3 each side)
Bar Mounting
Straps
Mounting Tube
(1 each side)
Mounting Bolt Holes
(2 each end)
Angle Mount
(2 each side)
Front
of
Frame
Rail
Advertisement
