Advertisement
Frame Rail Installation 2 WD & 4 WD
Tack Weld ing Frame Rails:
8.
Weld Bar Mounting Straps. The Rear
bar Mounting Straps will have to be cut (See
Figure 31) and welded to the top of the
Mounting Tube (See Figure 43). Another
one cut off and welded to the Bottom of the
Frame Rail. (See Figure 45) The length of
these Bar mounting straps is cutso it will not
be sticking over past frame rail.
These can be Tack Welded while still
mounted on Tractor, Illustrations are shown
with frame rails off of Tractor because it is
easier to see and it can be done after they are
removed from tractor if you want.
These must be Tack welded in align-
ment when installed, so the holes are in line.
If not in line the Bolt cannot be installed.
Measure the distance from the Angle Mount-
ing to the Mounting Bar that you have welded
to the mounting Tube. (See Figure 43).
Transfer that measurement to the bottom of
the Frame Rail and Tack Weld a cut off Bar
Mounting Strap there. (See Figure 44). Fig-
ure 44 shows a top (Un-Cut) Mounting Bar
being held down with a C-Clamp, this is done
to make it easier to transfer measurement to
lower Bar Mounting Strap. Do not weld a
strap to the top of the Frame Rail here. (See
Figure 44)
9.
Recheck that all components are
Tack Welded. (See Figures 31 through 45)
Do Not
Weld Here
Figure 44
Machete (JD-62, 63, 6420 Asy Man) 10/04
© 2004 Alamo Group Inc.
(continued)
Measure
Distance Here
&
Transfer
Measurement
to Here
Lower Bar Mounting
Strap (Cutt Off) Weld
Here
Section 4 - 20
Tack Weld Here
in 3 places on top
and 3 places on
bottom
Figure 42
Cut Straps
Here
Figure 43
Figure 45
Mounting
Tube
Measure
Distance Here
Upper Bar Mounting
Strap (Cut Off)
Lower Bar
Mounting Strap
(Cut Off)
Advertisement
