Installation Overview - Cleveland SteamCraft V Service Manual

Page 4 CET-16 Service Manual

INSTALLATION OVERVIEW

TASK
Preparation
Test SteamCraft V Water Supply
Install Water Treatment System
Select SteamCraft V location
Install Power Line
Extend Water Line(s)
Extend Drain Line
Installation
Unpack and Inspect SteamCraft V
Assemble Parts Shipped Loose
Position and Level SteamCraft V
Connect Electrical Line
Connect Untreated Water Line
Connect Treated Water Line
Connect Drain Line
Perform Setup and Checkout
Perform Function Test
Printed 4/90
equipment design and construction are: UL, A.G.A., ASME/N. Bd., NSF,
CSA, CGA, ETL, and others.
• This equipment is designed and certified for safe operation only when
permanently installed i
Many local codes exist, and it is the responsibility of the owner and
installer to comply with these codes.
• In no event shall the manufacturer assume any liability for damage or
injury resulting from installations which are not in strict compliance with
the Installation Instructions and the codes cited above. Specifically, the
manufacturer will not assume any liability for damage or injury resulting
from improper installation of equipment, including, but not limited to,
temporary or mobile installations.
Schematic Installation Diagram,
electrical, water, and drain lines that must be connected to the SteamCraft
V. These lines can be constructed and connected to the SteamCraft V
easily and without delay if the various construction and installation tasks
are performed a planned sequence. Table 2-1 summarizes these tasks
and lists them in a recommended sequence. The Installation Checklist
outlines the overall installation process; the instructions referenced in the
table provide details Installation requirements may vary from site to site;
adapt the checklist accordingly.
Table 2-1. Installation Check List
PAGE REFERENCE
6
6
7
7
9
10
11
13
14
16
17
18
20
20
21
23
n
accordance with local and/or national codes.
figure 2-1
, illustrates the various
COMPLETED