SteamCraft V Operating Location
CET-16 Service Manual
Table 2-2. Minimum Feed Water Quality Requirements
Total Dissolved Solids
Silica
Alkalinity
pH factor
When selecting an operating location for the SteamCraftV, observe the
following criteria.
• The SteamCraft V takes up a minimum of counter space. Figure 2 -4
illustrates the dimensions and clearances required. The 3'' clearance at
the rear includes spacing for the water inlet strainer and fittings, and
the maximum size (2" NPT) drain fittings.
• Figure 2-4 illustrates a left hand door hinge. A right hand door hinge
(model # DHR-5) is also available for the SteamCraft V.
Page 7
less than 60 pans per million
less than 13 pans per million
less than 20 pans per minion
greater than 7.5
Printed 4/90