Cleveland SteamCraft V Service Manual page 29

a. Support the control panel so it doesn't fall when the mounting
are removed.
b. DO NOT DISCONNECT any of the control panel wiring.
c. Refer to figure 2-23, and remove the mounting screws. Save the
screws. Place the panel upright at the base of the steamer.
d. Set a magnet over the door switch as shown in figure 2-23.
DAMAGE TO PANEL ELECTRONICS could result
from water splashing or spilling on the circuit board. If
water spills or splashes on the circuit board during this
test, immediately turn power OFF at the disconnect
switch.
2. Open the water supply valve to the steamer and open the steamer
drain valve.
3. Turn electricity on at the disconnect switch. Press the POWER touch
pad. Check that the red light over the POWER touch pad is on.
4. Water flows through the steamer and drain. Check for water leakage
at pipe joints and tube connections or unions. Wait for a few minutes,
then look for water leaking from the steam generator. Repair any
leaks before continuing.
5. As illustrated in figure2-24, use a screwdriver to short the flood probe
to ground for four seconds. The FLOOD alarm light flashes. Push the
POWER touch pad. The unit will not turn on. The FLOOD alarm light
continues to flash.
6. Turn electricity off at the disconnect switch. Wait ten seconds. Turn
electricity on at the disconnect switch.
7. Close the steam generator drain valve.
8. Press the POWER touch pad on the Control Panel.
9. The red fight above the touch pad turns on. The alarm WATER
displays and TIME displays.
10. After about five seconds, the water solenoid operates, filling the
steam generator with water. Check for water leakage around the
steam generator.
11. If the control panel was removed to observe the internal pipes and
fittings, replace it as follows.
Avoid contact with exposed electric circuits.
CET-16 Service Manual
CAUTION
WARNING
Printed 4/90
Page 25
screws