No Reinforcement Strips On The Output Without An Error Message - Oce TDS400 User Manual

[116] Opening the guide plates
Remove all tape between the rollers and knives (see Figure 117).
3
[117] Removing the tape
Lead a new trailing strip of tape between the rollers and knives.
4

No reinforcement strips on the output without an error message

Solve this error
Put the printer off-line by pressing the On-line key on the operator panel.
1
Open the side door of the reinforcement unit.
2
Check if there are loose reinforcement strips in the unit with the protection
3
sheet still on (see situation B in figure 118).
192 Océ TDS400 User Manual