[109] Opening the plate
Remove any jammed printing material.
3
Squeeze the two knobs again and put the plate in its original position.
4
Release the green lever in the lower section of the belt unit (by slightly lifting
5
it and pulling it forward) to open the lower plate (see Figure 110).
[110] Opening the lower plate
Remove any jammed printing material.
6
Pull up the green lever again (until it locks into position) to close the plate.
7
Close the belt unit door.
8
Put the belt in its operating position by pushing it down gently.
9
188
Océ TDS400 User Manual