Press the
7
Select 'Trailing' or 'Leading'.
8
Set the drawing method
Press the On-line key on the printer operator panel.
1
Select 'Folding' with the
2
Press the
3
Select 'Input' with the
4
Press the
5
Select 'Method' with the
6
Press the
7
Select 'Standard', 'Afnor' or 'Ericsson'.
8
Set the binding method
Press the On-line key on the printer operator panel.
1
Select 'Folding' with the
2
Press the
3
Select 'Binding' with the
4
Press the
5
Select 'Off', 'On' or 'Reinforce'.
6
to clean the reinforcement knives see page 172.
Note:
Set the binding edge value
Press the On-line key on the printer operator panel.
1
Select 'Folding' with the
2
Press the
3
Select 'Binding edge' with the
4
Press the
5
If you selected 'On' in the 'Select the binding method' procedure, enter a range
6
between 15 - 30 mm in steps of 1 mm; default 20 mm.
Set the folded package length
Press the On-line key on the printer operator panel.
1
Select 'Folding' with the
2
Press the
3
Select 'Package' with the
4
Press the
5
Select 'Length' with the
6
Press the
7
Enter a range between 276 - 310 mm in steps of 1 mm; default 297 mm.
198
Océ TDS400 User Manual
key to enter the 'Legend' menu.
or
key to enter the 'Folding' menu.
or
key.
key to enter the 'Input' menu.
or
key to enter the 'Method' menu.
or
key to enter the 'Folding' menu.
or
key to enter the 'Binding' menu.
or
key to enter the 'Folding' menu.
key to enter the 'Binding edge' menu.
or
key to enter the 'Folding' menu.
or
key to enter the 'Package' menu.
or
key to enter the 'Length' menu.
key.
key.
key.
key.
key.
or
key.
key.
key.
key.