Oce TDS400 User Manual page 43

Status Messages (continued)
Status messages Explanation
Sensor not free
Remove paper
Press <on-line>
Paper retracted
Press <on-line>
Copy too short
Remove paper
Press <on-line>
Inputflap open
Close inputflap
Inputflap open
Remove paper
Press <on-line>
Roll 1 empty
Open roll unit
Roll 2 empty
Open roll unit
Wait for folder
Folder is off
Folder belt full
RU tape empty
Using the Océ TDS400 to Print
The paper of one of the rolls is transferred after the marker (see
'Feed the material' on page 155) when power is applied to the
printer.
Take the paper back.
Press <on-line>
Put the paper into the manual feed.
Press <on-line>
The length of the print material is less than 420 mm. This can oc-
cur with the manual feed.
Use an original longer than 420 mm.
The input flap is open.
Close the input flap.
The input flap is open during the print process
Remove the paper and press <on-line>.
The paper on roll 1 is empty.
Open the roll unit and replace it.
The paper on roll 2 is empty.
Open the roll unit and replace it.
The communication between the printer and the folder starts up.
The communication between the printer and the folder was not es-
tablished.
The belt of the folder is full.
Empty the belt of the folder.
The tape roll of the reinforcement unit is empty.
Open the reinforcement unit and replace the empty tape roll.
43