Testing The Remote Control; Keypad - Response SA1 Installation & Operating Manual

5. Replace the rear cover and fixing screw.
House Code
Dip Switches
Jumper Link
Battery Clip
Battery

TESTING THE REMOTE CONTROL

1. Stand within view of the Solar Siren, press and hold
the 'INSTANT-ARM' button on the Remote Control
for approximately 10 seconds until the Solar Siren
acknowledges the signal by emitting one long Beep
(unless Beep Disable has been set). This operation
takes the Solar Siren out of Service mode and into
Operating mode (in a Disarmed state).
Note: The 'INSTANT-ARM' button should be
released during or immediately after the long
beep, otherwise the system will switch into an
Armed state.
If the Siren continuously sounds at this point it
is likely that the anti tamper switch on the Siren
has not been closed. Press the 'DISARM' button
on the Remote Control to switch OFF the Siren.
Remove the Siren from the mounting plate
and adjust the screw on the tamper knob to
ensure the switch closes when the Siren is
secured in position.
2. Arm the system in Instant mode by pressing the
'INSTANT-ARM' button. The Siren will acknowledge
the signal by beeping once.
3. Disarm the system by pressing the 'DISARM'
button. The Siren will acknowledge the signal by
beeping twice.
4. Arm the system in Delay mode by pressing the
'DELAY-ARM' button. The Siren will acknowledge
the signal by beeping once and then again after
the 15s entry/exit delay has expired.
SA1/SA2/SAC1
5. Disarm the system by pressing the 'DISARM'
button. The Siren will acknowledge the signal by
beeping twice.
6. To test the range of the Solar Siren and Remote
Control, press the 'DISARM' button on the Remote
Control from in and around the property and from
all locations where you plan to install detectors,
check that the Siren acknowledges the signals
from the Remote Control by beeping twice each
time the 'DISARM' button is pressed.
7. When you have finished testing the Remote Control,
return the system to Service mode by pressing and
holding the 'DISARM' button on the Remote Control
for approximately 10 seconds until the Solar Siren
acknowledges the signal by emitting one long Beep
(unless Beep Disable has been set)
IMPORTANT
Ensure that the system is in Service mode before
proceeding with the installation, otherwise a full alarm
condition could occur.

KEYPAD

The Remote Keypad is used to control the Solar
Siren and to Arm and Disarm the system by entering
a four digit User Access Code. The Keypad can arm
the system in either Instant or Delay modes.
The Keypad incorporates an anti tamper protection
facility. Any attempt to open the casing of the Keypad
will immediately initiate a Full Alarm condition even if
the system is disarmed, (unless the system is in
Service mode). In addition if a sequence of more than
16 incorrect key presses in entered the keypad will be
disabled for the next 15s, (except the tamper
protection function).
The Keypad also incorporates a Personal Attack (PA)
facility which will immediately initiate a Full Alarm
condition when activated.
The Keypad is powered by a PP3 Alkaline battery
which under normal conditions will have an expected
life in excess of 2 years. When the battery level drops
and the "LOW BATT" LED on the front of the Keypad
will flash. When this occurs the batteries should be
replaced as soon as possible.
7