Console Installation (Stand-Alone Telephone) - VTech UP416 User Manual

Getting started

Console installation (stand-alone telephone)

This UP416 console can be used as a stand-alone telephone without
connecting it to UP406 desksets via an Ethernet network.
Follow the steps below to set up the console if you
do not connect it to an Ethernet network.
1. Follow the steps on pages 11- 14 to connect the line
cords and adjust the console's viewing angle.
When the screen displays Is this Console going
2.
to register UP406 Desksets? 'SELECT': Yes
'CANCEL': No, press CANCEL. The screen displays
Console is in standalone mode.
The screen displays Starting... It takes a while for the
3.
system to finish the startup. The console enters the
idle screen when the startup is done.
4. Lift the handset. If you hear a dial tone, the installation
was successful.
You may change the stand-alone telephone to a
system telephone (with use of UP406 deskset) at a
later stage. Follow the steps below if you want to do so.
1. Connect the Ethernet cable between the console and the Ethernet switch or
router (see pages 13- 14 for details).
Follow steps 1-8 in To enable the Auto set IP under the Network setup
2.
section on page 33 to obtain an IP automatically.
-OR-
If you cannot obtain an IP automatically and need to enter one manually,
see steps 1-8 in To enable the Set static IP under the Network setup
section on pages 34 - 35 for details.
You may now connect UP406 deskset to the console. See Connecting
3.
desksets on pages 23- 24 for installation instructions.
17
Is this Console
going to register
UP406 Desksets?
'SELECT': Yes
'CANCEL': No
Console is in
standalone mode