Poe Commands; Config Poe - D-Link DGS-3100 Series Cli Manual

The PoE commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command

config poe

config poe ports
show poe
Each command is listed in detail, as follows:
config poe
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To config the PoE System on the Switch:
DGS3100# config poe system_power_limit 300 disconnect_method deny_next_port
Success.
Parameter
box_id <value 1-6> system_power_limit [ps1 | ps2 | ps3] disconnect_method
[deny_next_port | deny_low_priority_port]
<portlist> { state [enable | disable] | priority [low | high | critical] | power_limit
<value 1-15400>}
To configure the parameters for the whole PoE system.
config poe box_id <value 1-6> system_power_limit [ps1 | ps2 |
ps3] disconnect_method [deny_next_port |
deny_low_priority_port]
The config poe command configures the parameters for the PoE
system on a unit member of the stack.
box_id <value 1-6> – The unit's current stack membership number.
system_power_limit [ps1 | ps2 | ps3] – Specifies the power budget of
the whole PoE system, according to the type of power supply used
(ps1, ps2, ps3).
disconnect_method – Configures the power management
disconnection method. When the total consumed power exceeds the
power budget, the PoE controller initiates a port disconnection to
prevent overloading the power supply. The controller uses one of the
following two ways to implement the disconnection:
•
deny_next_port – After the power budget has been
exceeded, the next port attempting to power up is
denied, regardless of its priority. This is the default
setting.
•
deny_low_priority_port – After the power budget has
been exceeded, the next port attempting to power up,
causes the port with the lowest priority to shut down (to
allow high-priority ports to power up).
Only administrator-level users can issue this command.
159
29
P E C
O OMMANDS