Introduction - D-Link DGS-3100 Series Cli Manual

The DGS-3100 is a member of the D-Link DGS-3100 switch family. The DGS 3100 product range consists of 24
/ 48 -port 10/100/1000Base-T PoE / NonPoE L2 Stackable Management Switches with 4 Combo SFPs.
The Switch can be managed through the Switch's serial port, Telnet, or the Web-based management agent. The
Command Line Interface (CLI) can be used to configure and manage the Switch via the serial port or Telnet
interfaces.
This manual provides a reference for all of the commands contained in the CLI. Configuration and management
of the Switch via the Web-based management agent is discussed in the Manual. For detailed information on
installing hardware please refer also to the Manual.
Accessing the Switch via the Serial Port
The Switch's serial port's default settings are as follows:
•
9600 bps
•
No parity
•
8 data bits
•
1 stop bit
A computer running a terminal emulation program capable of emulating a VT-100 terminal and a serial port
configured as above is then connected to the Switch's serial port via an RS-232 DB-9 cable.
With the serial port properly connected to a management computer, the following screen should be visible. If this
screen does not appear, try pressing Ctrl+r to refresh the console screen.
The initial username is admin (lower case). Press the Enter key twice to display the CLI input cursor. This is the
command line where all commands are input.
Setting the Switch's IP Address
Each Switch must be assigned its own IP Address, which is used for communication with an SNMP network
manager or other TCP/IP application (for example BOOTP, TFTP). The Switch's default IP address is
10.90.90.90. You can change the default Switch IP address to meet the specification of your networking address
scheme.
The Switch is also assigned a unique MAC address by the factory. This MAC address cannot be changed, and
can be found on the initial boot console screen – shown below.
Figure 1–1. Initial CLI screen
1
1
I
NTRODUCTION
[