Config Stp Instance_Id - D-Link DGS-3100 Series Cli Manual

DGS-3100 Gigabit Ethernet Switch Manual

config stp instance_id

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure instance id 2 to a
To remove VID 10 from insta
1 1
DGS3100#
To add or delete an STP instance ID.
config stp instance_id <value 1-15> [add_vlan | remove_vlan]
<vidlist>
The config stp instance_id command maps VIDs (VLAN I
previously configured STP instances on the Switch by creating an
instance_id. A STP instance may have multiple members with the
same MSTP configuration. There is no limit to the number of STP
regions in a network but each region only supports a maximum of 16
spanning tree instances (one unchangeable default entry). VIDs can
belong to only one spanning tree instance at a time.
Note that switches in the same spanning tree region having the
same STP instance_id must be mapped identically, and have the
same configuration revision_level number and the same name.
<value 1-15> - The value of the instance_id. The value may be
between 1 and 15. The Switch supports 16 STP regions with one
unchangeable default instance ID set as 0.
add_vlan – Indicates that VIDs specified in the <vidlist> parameter
are to be added to the previously configured STP instance_id.
remove_vlan – Indicates that VIDs specified in the <vidlist>
parameter are to be removed from the previously configured STP
instance_id.
<vidlist> – Specifies the range of VIDs to add to or remove from the
configured STP instance_id. Supported VIDs on the Switch range
from ID number 1 to 4094.
Only administrator-level users can issue this command.
dd VID 10:
DGS3100# co ig nf stp instance_id 2 add_vlan 10
Success.
DGS3100#
nce id 2:
DGS3100 # config stp instance_id 2 remove_vlan 10
Succes s.
DGS3100#
66
Ds) to