Forwarding Database Commands; Create Fdb - D-Link DGS-3100 Series Cli Manual

DGS-3100 Gigabit Ethernet Switch Manual
The Forwardi ng Data base comman
parameters) in the following table.
Command

create fdb

create multicast_fdb
config multicast_fdb
config fdb aging_time
delete fdb
clear fdb
show mul ticast_fdb
show fdb
Each co mmand is listed in detail
create fdb
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To cr eate a unicast M
F
ORWARDI
ds in the Command Line Interface (CLI) a
Parameter
<vlan_name 32> <macaddr> port <port>
<vlan_name 32> <macaddr>
<vlan_name 32><macaddr> [add | delete] <portlist>
<value 10-630>
<vlan_name 32> <macaddr>
all
{vlan < vlan_name 32> | mac_address <macaddr>}
{port < port> | vlan <vlan_name 32>
aging_ time}
, as follows:
To create a static entry in the unicast MAC address forwarding table
(datab ase)
create fdb <vlan_name 32> <macaddr> port <port>
The create fdb command creates a static entry in the Switch's
unicast MAC address forwarding database.
<vlan_name 32> − The name of the VLAN on whic
address resides.
<macaddr> − The MAC address to be adde
port <port> − The port number corresponding to the MAC
destination address. The Swit
specified device through this port.
Only administrato
AC FDB entry:
DGS3100# create fdb default 00-00-00-00-01-02 port 2
Success.
D GS3100#
D
NG ATABASE
| mac_address <macaddr> | static |
ch will always forward traffic to the
r-level users can issue this command.
70
10
C
OMMANDS
re listed (along with the appropriate
h the MAC
d to the forwarding table.