Config Gvrp; Enable Gvrp - D-Link DGS-3100 Series Cli Manual

DGS-3100 Gigabit Ethernet Switch Manual

config gvrp

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set the ingress c

enable gvrp

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the generic VLAN Registration Protocol (GVRP):
To configure GVRP on the Switch.
config gvrp [<portlist> | <ch1-32> | all] { ingress_checking
[enable | disable] | acceptable_frame [tagged_only | admit_all] |
pvid <vlanid 1-4094>}
The config gvrp command configures the Group VLAN Registration
Protocol on the Switch. The user can configure ingress checking, the
sending and receiving of GVRP information, and the Port VLAN ID
(PVID).
<portlist> − A port or range of ports for
− assigns ports to a port-channel.
ch 1-32
all − Sp ecifies all ports on the Switch.
ingress_checking [enable | disable] − Enables or disables ingress
che cking for the specified port list.
acceptable_frame [
frame accepted. Accepta
only (tagged_only) or can accept tagged and untagged (admit_all).
pvid <vlanid 1-4
the port, by VLAN ID.
Only administrator-level users can issue this command.
hecking status, the sending and receiving GVRP information :
DGS3100# config gvrp 1-4 state enable ingress
acceptable_frame tagged_only pvid 2
S uccess.
DGS3100#
To enable GVRP on the Switch.
enable gvrp
The enable gvrp command, along with the disable gvrp command
below, is used to enable and disable GVRP on the Switch, without
changing the GVRP configuration on the Switch.
None.
Only administrator-level users can issue this command.
DGS3100# enable gvrp
Success.
DGS3100#
tagged_only | admit_all] – Defines the type of
ble frames can be limited to tagged frames
094> – Specifies the default VLAN associated with
90
which to configure GVRP.
_checking enable