Network Monitoring Commands; Show Packet Ports - D-Link DGS-3100 Series Cli Manual

DGS-3100 Gigabit Ethernet Switch Manual
The Network Monitoring command
parameters) in the following table.
Command

show packet ports

show error ports
show utilization
clear counters
clear log
show log
enable syslog
disable syslog
show syslog
create syslog host
config syslog host
delete syslog host
show syslog host
Each command is listed i n detail, as follows:
show packet ports
Purpose
Syntax
Description
Parameters
Restrictions
N
ETW
s in the Command Line I
Parameter
<portlist>
<portlist>
{index <value>}
<index 1-4> ipaddress <ipaddr> {seve
[local0 | local1| local2 | loca
<udp_port_number>}
[all | <index 1-4>] {severity
local2 | local3 | local4 | loca
ipaddress <ipaddr>}
[<index 1-4> | all]
{<index 1-4>}
To display statistics about the packets sent and received by the
Switch.
show packet ports <portlist>
The show packet ports command displays statistics about packets
sent and received by ports specified in t
separated into three tables, labeled A,
below. Table A
relevant to the type of packets and Table C is relevant to the type of
frame associated with these packets.
t> − A port or range of ports whose statistics are to be
<portlis
displaye d.
None.
M
ORK ONITORING
nterface (CLI) are listed (along with the appropriate
rity [informational | warning | all] | facility
l3 | local4 | local5 | local6 | local7] | udp_port
[informational | warning | all] | facility [local0 | local1 |
l5 | local6 | local7] | udp_port <udp_port_number> |
is relevant to the size of the packets, Table B is
48
C
OMMANDS
he port list. The results are
B, and C in the window
8