Config 802.1X Auth_Protocol; Config 802.1X Reauth - D-Link DGS-3100 Series Cli Manual

DGS-3100 Gigabit Ethernet Switch Manual
Restrictions
Example usage:
To initialize the authentication state machine of all ports:

config 802.1x auth_protocol

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the RADIUS (AAA) authentication protocol on the Switch:
DGS3100# config 802.1x auth_protocol radius
Success.
DGS3100#

config 802.1x reauth

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure 802.1x reauthentication for ports 1-18:
ports <portlist> – A port or range of ports to be configured.
all – Specifies all of the ports on the Switch.
Only administrator-level users can issue this command.
DGS3100# config 802.1x init port_based ports all
Success.
DGS3100#
To configure the 802.1x authentication protocol on the Switch .
config 802.1x auth_protocol [radius | none]
The config 802.1x auth_protocol command enables configuration
of the authentication protocol.
radius – Uses the list of RADIUS servers for authentication.
none – Uses no authentication.
Only administrator-level users can issue this command.
To configure the 802.1x re-authentication feature of the Switch.
config 802.1x reauth port_based ports [<portlist> | all]
The config 802.1x reauth command re-authenticates a previously
authenticated device based on port number.
port_based – Instructs the Switch to re-authorize 802.1x functions
based only on the port number. Ports approved for re-authorization
can then be specified.
ports <portlist> – A port or range of ports to be re-authorized.
all – Specifies all of the ports on the Switch.
Only administrator-level users can issue this command.
108