Traffic Segmentation Commands; Config Traffic_Segmentation; Show Traffic_Segmentation - D-Link DGS-3100 Series Cli Manual

The Traffic Segmentation commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
config
traffic_segmentation
show traffic_
segmentation
Each command is listed in detail, as follows:

config traffic_segmentation

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure ports 1 through 10 to be able to forward frames to port 11 through 15:
DGS3100# config traffic_segmentation 1-10 forward_list 11-15
Success.
DGS3100#

show traffic_segmentation

Purpose
Syntax
Description
T
RAFFIC
Parameter
[<portlist> | <ch1-32>] forward_list [null | <portlist> | <ch1-32>]
{<portlist>}
To configure traffic segmentation on the Switch.
config traffic_segmentation [<portlist> | <ch1-32>] forward_list
[null | <portlist> | <ch1-32>]
The config traffic_segmentation command configures traffic
segmentation on the Switch.
<portlist> | <ch1-32> – A port or range of ports or a port channel to
be configured for traffic segmentation.
forward_list – Specifies a port or range of ports to receive forwarded
frames from the ports specified in the portlist, above.
•
null – No ports are specified.
•
<portlist> | <ch1-32> – Specifies a port or range of ports or
port channel for the forwarding list. This list must be on the
same switch previously specified for traffic segmentation.
Only administrator-level users can issue this command.
To display the current traffic segmentation configuration on the
Switch
show traffic_segmentation {<portlist>}
The show traffic_segmentation command displays the current
S
EGMENTATION
171
31
C
OMMANDS