Config 802.1X Auth_Mode; Config Guest_Vlan - D-Link DGS-3100 Series Cli Manual

DGS3100# show radius
Index
--------
1
DGS3100#

config 802.1x auth_mode

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure 802.1x authentication by MAC address:
DGS3100# config 802.1x auth_mode mac_based
Success.
DGS3100#

config guest_vlan

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable a Guest VLAN:
IP Address Auth-Port
Number
---------------- --------------
10.1.1.1 1812
To configure the 802.1x authentication mode on the Switch.
config 802.1x auth_mode ports <portlist> [port_based |
mac_based]
The config 802.1x auth_mode command enables either the port-
based or MAC-based 802.1x authentication feature on the Switch.
portlist – A port or a range of ports to be configured.
[port_based | mac_based] – Specifies whether 802.1x authentication
is by port or MAC address.
Only administrator-level users can issue this command.
Enables or disables network access to a Guest VLAN.
config guest_vlan <vlan_name 32> state [enable | disable]
The config guest_vlan command enables or disables network
access to a Guest VLAN. A network administrator can use Guest
VLANs to deny network access via port-based authentication, but
grant Internet access to unauthorized users.
<vlan_name 32> – The name of the Guest VLAN.
state [enable | disable] – Enables or disables network access to the
Guest VLAN.
Only administrator-level users can issue this command.
DGS3100# config guest_vlan guestusers state enable
DGS3100#
Acct-Port Status
Number
-------------- ------------ ---------------------
1813 Active
111
Key
switch