Datamax I-Class Mark II Maintenance Manual page 45

I-Class Mark II Maintenance Manual
Fault Messages (continued)
Displayed
Description
Message
The present
sensor (if
Present Sensor equipped) has
Remove Label detect a label
blocking the
sensor.
The GPIO option
card (if
equipped) is
GPIO
awaiting a
Waiting for
signal from the
Signal
host or other
remote
equipment.
The GPIO option
card (if
GPIO
equipped) is
Waiting for Data
awaiting data
from the host.
Solution
1) Remove the label if present.
2) The Present Sensor may be defective; replace.
Refer to the GPIO Installation Instructions
included with the option or downloaded from
www.datamax-oneil.com.
Refer to the GPIO Installation Instructions
included with the option or downloaded from
www.datamax-oneil.com.
41
Troubleshooting
LED Status
Flashing Yellow
GREEN: OFF
RED: OFF
GREEN: ON
RED: OFF
GREEN: ON