4.14.1 Ribbon Supply Hub - Datamax I-Class Mark II Maintenance Manual
Hide thumbs
Also See for I-Class Mark II:
- Operator's manual (96 pages) ,
- Installation and use manual (12 pages) ,
- Quick start manual (4 pages)
Table of Contents
Advertisement
I-Class Mark II Maintenance Manual
4.14.1 Ribbon Supply Hub
Removal:
1. Remove the Thermal Transfer Assembly; see Section 4.14.
2. Remove the Screw and Metal Washer that secures the Ribbon Supply Hub to the Housing.
3. Remove the Ribbon Supply Hub and Nylon Washer from the Housing.
Supply Hub
Replacement:
1. Place the Nylon Washer over the Shaft into the Ribbon Supply Hub housing.
2. Slide the Ribbon Supply Hub shaft into the Housing.
Ribbon
Ribbon
Supply Hub
Removal and Replacement
Housing
Metal
Nylon
Washer
Washer
Nylon
Washer
Timing
Disk
66
Screw
Shaft
Hide quick links:
Advertisement
Table of Contents
