Installing The Phaser 540 Driver - Tektronix Phaser 540 Plus User Manual

Installing the Phaser 540 driver

1.
Make sure that your Macintosh is turned on with System Software
version 6.0.7, 7.0 or later installed.
2.
Insert the Macintosh Driver and Printer Utilities diskette into the
disk drive. When the diskette appears on the desktop, it should be
open, showing the icons inside.
3. Drag the Phaser 540 driver icon from the diskette to the closed
System Folder icon on your Macintosh hard disk.
System 7.0 and higher users: at the alert message, click
automatically install the driver in the Extensions folder.
System 6.0.7 users: the driver is installed in the System Folder.
4. System 6.0.7 users: LaserWriter 7.1.2 software is required to use
the Tektronix driver with system 6.0.7. If you need this software,
do the following steps:
a.
Open the Old System Items folder on the Macintosh Driver and
Printer Utilities diskette.
b. Drag the Backgrounder V1.3 and PrintMonitor V7.0 from the
diskette to the closed System Folder icon on your Macintosh
hard disk. At the alert message, click
install these items in their proper places.
5. Select Chooser from the Apple menu.
6. Click the Phaser 540 printer driver icon on the left side of the
Chooser. A list appears with the printers you have connected to
your Macintosh or printers that are available on a network. (If the
printer driver icon does not appear, Restart your Macintosh, and
repeat the printer driver installation procedure; also check the
cable connections on your computer and printer.)
7.
Click on the Phaser 540 printer in the list of printers on the right
side of the Chooser.
8. Close the Chooser by clicking its close box.
9.
Store the printer diskette in a safe place.
Getting Set Up
OK to
OK to automatically
User Manual
2
2-33