Installing A Scsi Hard Disk Drive On A Phaser 440; Figure 2-3 Connecting A Scsi Hard Disk Drive To A Phaser 440 - Tektronix Phaser 440 Service Manual

Installing a SCSI hard disk drive on a Phaser 440

Perform this procedure if the customer has a hard disk drive available for font
storage. Otherwise, continue to the next procedure.
1. Make sure that the printer and the SCSI disk drive are turned off.
2. Attach the SCSI cable to the printer's SCSI port.
3.
Attach the other end of the SCSI cable to the SCSI drive.
4. Attach a terminator to the SCSI drive's second connector. (This is not
required if the disk drive is internally terminated.)
1 2
1 2 3 4 5 6 7 8 9
Reset Service On 1200 Skip On
Diagnostics Blue Adj. Baud Rate Start Job Press Adj.
Serial Run Power Up Off Variable Run Off
(RS-232)
Status
Parallel
LocalTalk®
SCSI Disk
Ethernet®
Ethernet Address
Not Installed
PHASER 200i
MODEL 4681 PXi

Figure 2-3 Connecting a SCSI hard disk drive to a Phaser 440

5. Turn on the disk drive first, and then the printer.
6.
Refer to the Phaser 440 Driver and Utilities Printing Reference for details
on formatting a SCSI disk, controlling Sys/Start job files, and using the
LaserWriter Utility to load fonts onto the disk drive.
Installing the Printer and Drivers
3 4
SCSI SCSI
Service Manual
2
2-11