Print Job Does Not Finish (The Printer Times Out); Error Indicator Is Blinking - Tektronix Phaser 540 Plus User Manual

6
Troubleshooting
6-18
Phaser 540 Color Printer
Print job does not finish (the printer times out)
If you are using the serial or parallel port from a PC, make sure that you
used the command to set the PC's communication parameters. For
MODE
example:
MODE LPT1:,,P > NUL
MODE COM1:9600,N,8,1,P
The parameter in these commands sets the port timeout to Infinite Retry
P
and must be part of the command.
If you are using Windows 3.1, make sure that the Transmission Retry value
for the printer's assigned port is set to 850. For more information, see
"PC: Microsoft Windows driver" on page 2-28.

Error indicator is blinking

The Error indicator blinks with any hard error, such as the following
circumstances:
Media jam
Any of the printer doors are open
Any of the user-replaceable components are missing
Look at the front panel for an indication of the type of error, then correct the
problem. If the front panel message is Printer Error ##, turn the printer
off and on again. If the Error indicator remains on after power-up, your
printer requires service. See "If you need help" on page 6-1 for telephone
information.