Print Job Does Not Finish (The Printer Times Out); Error Indicator Is Blinking - Tektronix Phaser 550 User Manual

Print job does not finish (the printer times out)
If you are using the serial or parallel port from a PC, make sure that you
used the command to set the PCÕs communication parameters. For
MODE
example:
MODE LPT1:,,P > NUL
MODE COM1:9600,N,8,1,P
The parameter in these commands sets the port timeout to Infinite Retry
P
and must be part of the command.
If you are using Windows 3.1, make sure that the Transmission Retry value
for the printerÕs assigned port is set to 850. For more information, see
ÒPC: Software for Microsoft Windows 3.1Ó on page 2-32.

Error indicator is blinking

The Error indicator blinks with any hard error, such as the following
circumstances:
Media jam
Any of the printer doors are open
Any of the user-replaceable components are missing
Look at the front panel for an indication of the type of error, then correct the problem. If the front
panel message is Printer Error ##, turn the printer off and on again. If the Error indicator
remains on after power-up, your printer requires service. See ÒIf you need
helpÓ on page 6-1 for telephone information.
Troubleshooting
6-23
User Manual
6