Setting The Signal Types Yuv (Hd) - Metz LCD-TV (F)HDTV-set Operating Instructions Manual

25. Registering AV Devices
Setting signal types YUV
Connection of external devices with YUV compo-
nent output to the "COMPONENT IN" RCA jacks.

The signal type always refers to the input
and output of the AV device.
AV devices equipped with a YUV jack can be con-
nected to the LCD TV by means of a YUV cable
(see page 97). In the "AV Devices" menu, the con-
nected AV device must be registered with signal
OUT "YUV".
The connection of the analogue YUV source using
the RCA jacks to the YUV input of the LCD TV
depends on the output format of the signal source.
Configure the following settings, depending on the
output format of your signal source:
Setting the YUV Signal Type
- Enter the TV menu by pres-
sing "MENU".
- Press the yellow key to open
the "AV Devices" menu.
- Use the cursor control to
select the AV device whose
signal type you want to
change and press "OK".
- Press numeric key
the cursor control to select
"Signal OUT", and use the -
+ key to set "YUV" or "YUV
(HD)".
- Confirm the setting by pressing "OK".
- Exit the "TV Menu" by pressing "EXIT".

Caution ! This may cause an existing con-
nection diagram to be modified. If so, you
must reconnect the AV devices accordingly.
AV devices
·
, use
Change with
Accept value with .
Opening the menu
F1
Other device 3
Other device 2
Other device 1
PC
Satellit / set top
DVD Player 2
DVD Player 1
DVD/Videorec.3
DVD/Videorec.2
DVD/Videorec.1
– +
OK
Signal OUT
The number of subjects and sections depends
on the selected scope of operation. Depending
on the configuration of the TV set, the various
menu items may be displayed in a different
order and numbered differently.
MENU
OK
DataLogic
TV-SPDIF input
Name
Signal types
✗
connect
YUV Signal IN no Signal
OK
EXIT
89