Operation Without The Remote Control; Connecting Headphones - Metz LCD-TV (F)HDTV-set Operating Instructions Manual

31. Operation without the Remote Control

Operation without the remote control is
provided as an emergency measure in
case the batteries of your remote control
are exhausted or the remote control is
not readily available.
The manual controls can be found on
the underside of the TV set, behind a
flap that is opened by pressing •••.
Switching on
Press the main power switch on the TV
set. After about five seconds, the TV set
is switched on with programme position
1 or the programmed initial programme
position selected.
You can also use the following functions
directly on the TV set, without a remote
control. For functions which require furt-
her adjustments, the function remains
preselected for ten seconds.
The headphone socket is located behind
a flap on the left side of the TV set (see
Section 34).
Press ••• to open the flap.
See also ch. 34.
We recommend the use of headphones
with an impedance of at least 32 Ω. The
use of headphones with a lower impe-
dance will reduce the dynamic range of
the sound.
You can save the headphone volume as
a standard value.
98

31.1 Connecting Headphones

Programme selection
Press the -/+ buttons.
Volume
Press and hold the preselection key F until
the bar display for the volume appears
on the screen. Then press the "-" or "+"
button to adjust the volume.
Contrast
Press and hold the preselection key F until
the bar display for the contrast appears
on the screen. Then press the "-" or "+"
button to adjust the contrast.
Setting the volume too high
when using headphones or
earphones can result in
damage to the ears - inclu-
ding the complete loss of
hearing.