Lnb Supply Voltage - Metz LCD-TV (F)HDTV-set Operating Instructions Manual

22.4. Set-up of satellite system

LNB supply voltage


Section 22.4 only in the case of corresponding equipment or conversion.
The settings of the satellite antenna system must
be entered in the menu "Configuration" so that
the TV set knows them.
i
These settings should always be made in the
order in which they are shown in the right-hand
column of the menu, starting at the bottom, i.e.
LNB supply voltage, DiSEqC system, etc..
LNB supply voltage
The LNB voltages for selection of the polarisation (hori-
zontal H = 18V, vertical V = 14V)
are already set and do not nor-
mally need to be changed.
If the cable to the satellite
antenna is very long, the vol-
tages reaching the LNB may
be too low. In such cases, the
voltages can be increased by
1 V by activating the line-
compensation function.
If any changes should be
necessary, they can be made
as follows.
Changing the settings
• Press the MENU key to open the TV menu.
• Press the red key
guration".
• Press the appropriate numeric key (in this exam-
ple to select "DVB-S".
• Press the OK key and, in the setting window,
use the - + key to switch the LNB supply voltage
on or off.
• Press the Ok key to confirm the new setting.
• Press the EXIT key to close the TV menu.

If the TV set is connected to a community
antenna, the LNB supply voltage must
always be set to "Off".
Configuration
Change with
– +
Accept value with .
to open the menu "Confi-
Calling the menu
Function for F2
Function for F1
EURO sockets
DVB-C
DVB-T
DVB-S
Analog-TV
Country
Language
Operating
OK
LNB supply voltage
The number of subjects and sections depends
on the selected scope of operation. Depending
on the configuration of the TV set, the various
menu items may be displayed in a different
order and numbered differently.
MENU
General settings
Manual search
Automatic search
Search settings
Satellit B
Astra 19,2°
DiSEqc system
LNB supply voltage
on Power compensation
OK
EXIT
75
off