Setting The Signal Types Yuv - Metz Axio pro Operating Instructions Manual

30.2 Registering AV Devices
Setting signal types YUV
Connection of external devices with YUV
nent output to the "COMPONENT IN" RCA jacks.
☞
The signal type always refers to the input
and output of the AV device.
AV devices equipped with a YUV jack
connected to the LCD TV by means of a YUV
cable (see page 116). In the "AV Devices" menu,
the connected AV device must be registered with
signal OUT "YUV".
The connection of the analogue YUV source using
the RCA jacks to the YUV input
depends on the output format of the signal source.
For YUV, the sound must be connected in addition
via a Cinch or optical audio cable (Toslink).
Configure the following settings, depending on
the output format of your signal
source:
Setting the YUV Signal Type
2)
• Enter the TV menu by pres-
sing .
• Press the yellow key
open the "AV Devices" menu.
• Use the cursor control to
select the AV device whose
signal type you want to
change and press
• Press numeric key
the cursor control to select
"Signal OUT", and use the
V-/V+ key to set "YUV" or "YUV (HD)".
• Confirm the setting by pressing
• Exit the "TV Menu" by pressing
☞
Caution ! This may cause an existing con-
nection diagram to be modified. If so, you
must reconnect the AV devices accordingly.
2)
can be
2)
of the LCD TV
2)
to
AV devices
.
·
, use
.
Opening the menu
2)
compo-
F1
Front HDMI
AV-Receiver
Other device 1
Other device 1
PC
Satellite / set top
DVD Player 2
DVD Player 1
DVD/Videorec.2
DVD/Videorec.1
Signal OUT
.
2) Possible only on sets equipped with this function.
MENU
DataLogic
TV-SPDIF input 2)
Name
Signal types
✗
connect
YUV Signal IN no Signal
EXIT
123