Colour Standard For Analogue Stations - Metz LCD-TV (F)HDTV-set Operating Instructions Manual

22.1 Setting Stations

Colour standard for analogue stations

The TV set will normally detect the colour standard
(PAL, SECAM, NTSC, NTSC44, PAL60, PAL M)
automatically.
If this automatic selection does not provide satis-
factory results (which should happen only rarely),
you can select the colour standard manually for
each programme position.
The colour standard is set in the factory to "Auto-
matic".
Setting the colour standard
• Press the "MENU" key to open the TV menu.
• Press the white key
open the station table.
• Press the F2 key to enable
editing of the station table.
• Use the cursor control key to
select the programme posi-
tion whose colour standard
you wish to change.
• Press the cursor control key
to move to the left
column.
• Use the corresponding
numeric key (in the example:
"Colour standard".
• Use the - + key to select the desired colour stan-
dard, or to step through the available colour
standards until the picture is displayed clearly.
• Press the "OK" key to confirm your selection.
• Press the "EXIT" key to close the TV menu.
to
Station table
Change with
– +
Accept value with
OK
) to select
Opening the menu
MENU
F2
F1
0010 Hessen 3
0009 Südwest
0008 MDR
0007 PRO 7
0006 RTL 2
0005 RTL
0004 SAT 1
0003 Bayern 3
0002 ZDF
0001 ARD
Colour standard SECAM
OK
EXIT
3) See glossary for an explanation.
5) Available only for DVB stations!
7) Available only for analogue stations!
Sound corrections
Colour standard 3)7)
Picture quality
Picture correct.
Enter logo
✗
Station contained in EPG
CA module 5)
Signal quality
5)
DVB-prog. info
5)
Frequency/channel
7)
69