Embroidery Unit - X-Unit; Belt Tension; Calibration Of The End Position, X-Unit - Husqvarna Viking Designer I Service Manual

Embroidery unit

Belt tension

Check
The belt should be adjusted in such a way that it should be possible to
push in the belt approx. 4,5 mm with a force of 0,2 kg.
Adjustment
Adjust by loosening the screw (A) and move the plate (B) until a good
belt tension is obtained.

Calibration of the end position, X-unit.

Check
Move the X-unit to that the calibration stop (E) is against the frame (F).
The distance between (A) and (B) should now be 2 mm.
Adjustment
1. Remove the holder (C) by removing the screws (D).
2. Move the Y-unit so that the distance between (A) and (B) is 2 mm.
3. Turn the cog wheel so that the calibration stop (E) is against the frame (F).
4. Mount the holder (C) with one leg on each side of the belt.
5 Check
60
Embroidery Unit
- X-unit
104 72 47-26