Mega Hoop; Connect The Embroidery Unit - Husqvarna Viking Designer SE User Manual

Mega Hoop

Sew embroideries that are up to 150 mm wide
and 360 mm high with the Mega Hoop. In
Embroidery Mode, select hoop size 360 x 150,
see page 4-5.
Follow the instructions included with your Mega
Hoop.
Designs for the Mega Hoop are included with
your Designer SE and pictured full size in the
Designer SE Sampler booklet.

Connect the Embroidery Unit

1. Press button at left end of accessory tray and
slide it off.
2. There is a covered socket at the back of the
machine. Turn the cover to the right to open
it. The embroidery unit plugs into the socket.
3. Slide the embroidery unit on to the free arm
of the machine until it plugs fi rmly into the
socket. If the machine is off, turn it on.
4. A pop-up window tells you to clear the
area and remove the hoop for positioning.
Touch . The machine will calibrate
and the em broi dery arm will move to the
ready po si tion. This calibration will set your
em broi dery func tions each time you sli de on
the em broi dery unit.
: Make sure not to calibrate the machine with
NOTE
the embroidery hoop attached as this can damage the
needle, hoop and/or the embroidery unit. Be sure to
clear all materials from around the machine before
calibrating so the embroidery arm does not bump
into anything while calibrating.
Set to Embroider
3-3