Programming The Answering Machine - ASCOM Eurit 40 Operating Instructions Manual

Telephone answering machine
Switching on the announcement
Announcement for "Memory full"
To record the announcement "Memory full" follow the steps in the Section "Recording / replaying /
deleting an announcement", Page 56.
The announcement "Memory full" should have a duration between 4 and 20 seconds.

Programming the answering machine

You can program the following settings on your answering machine:
Forward calls directly (without rings) to answering machine: You can forward all incoming
calls directly to your answering machine before the telephone rings.
Number of rings: You can set the permissible number of rings (3 to 9) before the answering
machine responds. The default setting is five rings.
The programming for the number of ringing signals is ignored when the charge saving function
(see below) is activated and at least one message has been recorded by the answering machine.
In this case the answering machine seizes the line 2 rings earlier than the programmed number
of ringing signals.
Enter the submenu Main menu/Answering machine/
Announcement.
Repeatedly press the Display key at the desired MSN until the desired
announcement number (1, 2, 3...8) is displayed.
Save the setting.
Enter the submenu Main menu/Answering machine/
Announcement.
Press the Cursor key to page forward in the menu.
Press the Display key at Memory full Mess.
57