Installing The Driver Software - GRAPHTEC CS600 User Manual

3. PREPARING TO OPERATE THE SCANNER

3.5 Installing the Driver Software

The procedure outlined below is based on the requirement that you are logged on
to Windows with administrator rights. Consult your Windows 2000 or Windows XP
manual for more information.
For Windows 2000
The following procedure assumes that you are using the CS600-11 connected via the USB
interface.
The scanner name displayed in the windows is the name of the scanner connected to the
computer (CS600-11 is used in this section).
(1) Connect the scanner to the computer, and turn on the computer's power. Insert the
CD-ROM disk (included with your computer) into the CD-ROM drive of the computer
after Windows has started up, and then turn on the scanner's power.
(2) [Next], the Found New Hardware Wizard appears.
3 – 20 CS600/CS500/IS200