Installing The Driver Software - GRAPHTEC CS400 User Manual

3. PREPARING TO OPERATE THE SCANNER

3.4 Installing the Driver Software

The procedure outlined below is based on the requirement that you are logged on
to Windows with administrator rights. Consult your Windows 2000 or Windows XP
manual for more information.
For Windows 2000
The following procedure assumes that you are using the CS400 as part of your system,
and that you are using the USB interface. If you are using the IEEE 1394 interface, GRAPHTEC
CS400-10 IEEE 1394 SBP2 Device will be displayed where CS400-10 is displayed when
the USB interface is used. Substitute CS300-10 for CS400-10 for guidelines as to how to
use the CS300.
(1) Connect the scanner to the computer, and turn on the computer's power. Insert the
CD-ROM disk (included with your computer) into the CD-ROM drive of the computer
after Windows has started up, and then turn on the scanner's power.
(2) The message below appears.
(3) Next, the Found New Hardware Wizard appears.
3 – 6 CS400/300