GRAPHTEC CS600 User Manual page 32

Turning the Power On and Off
Whenever the scanner's Power switch is turned on, the POWER, PAPER, and ERROR lamps
on the control panel light up. When the scanner has been initialized, the POWER lamp
lights up.
When resetting the scanner by turning it off then back on again, wait at least five
seconds before turning it back on.
Notes on the power-saving mode
The scanner switches to power-saving mode when the standby status continues for a fixed
amount of time.
When the scanner is in power-saving mode, the POWER LED blinks orange, and the scanner
goes into sleep status.
The amount of time before the scanner switches to power-saving mode differs according
to the interface selection switch setting.
When USB connection has been selected
When Ethernet connection has been selected
Note: The switch is set to USB connection at the time of shipment.
If a key is pressed or an operation such as inserting a document is performed while the
scanner is in power-saving mode, the scanner returns to the standard operating mode.
CS600/CS500/IS200
3. PREPARING TO OPERATE THE SCANNER
Approx. 13 minutes
Approx. 4 hours
3 – 3