Control panel (CS600)
POWER
PAPER
ERROR
SCAN
FORWARD
REVERSE
STOP
(used for automatic document thickness detection)
This key is used to switch between the ITA (document thickness detection)
and READY (normal) modes.
CS600/CS500/IS200
POWER LED
Unlit
: The scanner is turned off.
Lit (green)
: Lights when the scanner is turned on and remains
Flashing (orange) : Flashes while the scanner is in power-saving mode.
PAPER LED
Unlit
: Normal status (Local status).
Lit (green)
: Lights when a document has been loaded.
Flashing (green)
: Flashes if an abnormality is detected when the top
ERROR LED
Lit (red)
: Lights to indicate a hardware error.
Flashing (red)
: Flashes in the following cases.
Unlit
: Normal status
*1 When "Confirm" has been selected for the End-of-paper Processing setting
(
in the Scanning Master 21+ driver.
ITA key
READY LED
Lit (green):
: READY mode
Unlit
: ITA mode
ITA LED
Unlit:
: READY mode
Lit (green)
: ITA mode
Flashing (green)
: Flashes while a document is being scanned in ITA mode.
lit while it is operating normally.
cover is raised or lowered while image data is being
scanned.
When a document is detected during the self-test
when the scanner is turned on; when scanning is
suspended by pressing the STOP key; when a paper
jam is detected; when the document length is shorter
than the specified scan length*
is detected when the top cover is raised or lowered.
READY mode
ITA mode
2
Safety mode*
*2: When foreign matter is obstructing document movement, and so forth
2. PREPARATION
1
; or when an abnormality
READY LED
ITA LED
Lit green
Unlit
Lit green
Unlit
)
Unlit
Unlit
2 – 9
Need help?
Do you have a question about the CS600 and is the answer not in the manual?