GRAPHTEC CS600 User Manual page 52

For Windows XP
The following procedure assumes that you are using the CS600-11 connected via the USB
interface.
The scanner name displayed in the windows is the name of the scanner connected to the
computer (CS600-11 is used in this section).
(1) Connect the scanner to the computer, turn on the scanner first, and then turn on the
computer. When Windows starts up, insert the CD-ROM supplied with the scanner in
the CD-ROM drive. Turn on the power to the scanner.
(2) [Next], the Found New Hardware Wizard window appears. (If your version is pre-
Service Pack 2, the window shown in (3) appears.)
Click "No, not this time", and then click [Next].
(3) The following window appears.
Select the option "Install from a list or a specific location (Advanced)".
CS600/CS500/IS200
3. PREPARING TO OPERATE THE SCANNER
3 – 23