Connecting The Scanner Via An Ethernet Interface - GRAPHTEC CS600 User Manual

3. PREPARING TO OPERATE THE SCANNER

3.4 Connecting the Scanner via an Ethernet Interface

The procedure outlined below is based on the requirement that you are logged on
to Windows with administrator rights. Consult your Windows 2000 or Windows XP
manual or Windows Help for more information.
Installing the Network Utility
The following procedure assumes that you are using the CS600-11eN/11eN-PRO, CS500-
11eN/11eN-PRO, CS500-06eN-PRO, or the IS200-11eN/11eN-PRO connected via an Ethernet
interface as part of your system. The scanner name displayed in the windows is the name
of the scanner connected to the computer. The windows shown are those for Windows 2000.
(1) Connect the scanner to the computer, and turn on the computer's power. Insert the
CD-ROM disk (included with your computer) into the CD-ROM drive of the computer
after Windows has started up, and then turn on the scanner's power.
Note: If you have Windows XP Service Pack 2 installed in your computer, please see "For
Computers with Windows XP Service Pack 2 Installed" on page 3-12.
(2) When English\Network\Autorun.exe is executed, the following window appears.
3 – 6 CS600/CS500/IS200