Speed Dial - Extension/System - Comdial DX-80 Installation & Maintenance Manual

Conditions
a) The speakerphone function is impacted by environmental conditions.
b) Operation of the speakerphone in high-noise areas may yield less than adequate results. If this is the case
in the area where your telephone is located, the handset may be used to improve connection conditions.
c) To dial intercom numbers directly from an idle condition, the Hot Key setting must be Enabled. Otherwise,
the extension user must press a programmed Intercom Button or press the ON/OFF button prior to dialing
the extension number.
Speed Dial – Extension/System
Speed Dialing allows you to store frequently dialed numbers. These numbers are accessed for dialing by the
associated speed dial directory number (Speed Number Location). The directory number may be stored on any
feature button for instant one-button operation.
Extensions may store up to fifty (50) personal (extension) speed numbers in memory. (At default 20 personal
locations – numbered 470-489 are available for extensions 101-140). There are also two hundred (200) Speed Dial
bins allocated for system-wide use (locations 500-699). System Speed Dial is programmed via Attendant
Administration or via customer database programming.
You may choose to first press an idle CO line or you may let the system automatically select the line.
The DX-80 system can be programmed to allow System Speed Dial Numbers to override Toll Restriction settings
(both CO Line and Extension COS).
Related Features
Class of Service – Extension
Toll Restriction
Flexible System numbering Plan
Flash
Related Programming
System Resource - Speed Number Assignment, Speed Number Programming
Call Handling - Dial Wait Time, Dial Delay Time, System Speed Toll Check
System Application - Individual Speed Number
System Application - System Speed Number
Operation – Setting up Extension Speed Dial Numbers:
!1
1. Press .
2. Dial the Speed Dial location number (470~489).
show
3. Press [ ]. The current contents of this speed dial number location are displayed.
chg
4. Press [ ].
5. Input the number for this speed dial location including Pauses (
Tone Conversion (
save
6. Press [ ]. That number is stored in this speed dial location.
7. Continue programming speed dial locations from step 2 above or hang-up (press
Operation – Setting up System Speed Dial Numbers:
1. Use Database Administration (see Programming below)
Or...
2. Use Attendant Administration (see Attendant Administration.)
P7290 IMM
DX-80 I
NSTALLATION AND
*
) codes.
3-202
M M 03/01
AINTENANCE ANUAL
Pulse to DTMF Conversion
Attendant Administration
Tenant Groups
Pause
!70
), Flash (
!3
) and Pulse To
twice) to exit.