Reminder Tones; Remote Programming Via Pc-Dba - Comdial DX-80 Installation & Maintenance Manual

Operation – Setup: Program the feature button for Release Key operation.
1. While the telephone is idle press
2. Press the Flexible Feature Button that is to be used as the Release Key.
chg
3. Press [ ].
ftr
4. Press [ ].
5. Input the feature code prefaced with the
6. Exit the Flexible Feature Button programming mode.
Conditions
a) The Release Key must be programmed onto an available Feature Button to operate.
b) The Release Key operation will disconnect calls in progress.
Default Setting
No Release Key is programmed on the telephone Flexible Feature Buttons.

Reminder Tones

A specific interruption in intercom dial tone is provided to remind a user that a call processing affecting feature has
been invoked. Whenever Do Not Disturb or Call Forward is enabled at your extension will hear this reminder tone
when you access intercom dial tone. The distinction of Reminder Tone is a fast repeated interruption of intercom dial
tone. This tone is frequently referred to as "stutter" dial tone.
When you lift the handset or press the
indicates that Call Forward or Do Not Disturb is active.
Related Features
Do Not Disturb
Operation
Intercom dial tone will be appended with "Stutter Dial Tone" whenever the extension is used to place
intercom calls.
Conditions
Once you dial a digit the reminder tone is removed until the next time you access intercom.

Remote Programming via PC-DBA

Programming the DX-80 system database is possible in three ways. First it can be programmed by the telephone,
second via PC-DBA on site, and third via PC-DBA remotely via modem. Refer to the feature description and
operation for Database Administration – Via PC-DBA for instructions on how to establish a modem connection and
then for programming system changes.
Emphasis must be placed on the F4-Send and F3-Receive functions.
The various setup parameters of the DX-80 system for use with a modem are described here. The DX-80 system
remote access parameters "Built-in Modem" (DIR No. and Baud Rate) must be set to allow access to the DX-80. The
parameters "PC-DBA Connection" (Auto Log Off and Log On Again) can be set to avoid unauthorized access to the
DX-80 database.
Built-in Modem – Baud Rate is a data link speed setting requirement. This setting is defaulted at 2400 bps but can be
changed to 1200 bps if necessary. The Directory Number setting is defaulted at extension 199. This also may be
changed if necessary. Regardless of the modem extension (directory number), this number is used to connect the
external PC-DBA calling modem to the internal DX-80 modem.
P7290 IMM
DX-80 I M
NSTALLATION AND AINTENANCE
!/3
.
!
button
button to active speakerphone or headset mode. Stutter dial tone
Call Forward
3-194
M 03/01
ANUAL
!52
save
. Then press [ ].