Copying Crash Data Content To A Destination Device - HP PROCURVE 6120 Management And Configuration Manual

File Transfers
Copying Diagnostic Data to a Remote Host, USB Device, PC or UNIX Workstation
At this point, press
[Enter] and start the
Xmodem command
sequence in your
terminal emulator.
Figure A-12. Example of Sending Event Log Content to a File on an Attached PC
At this point, press
[Enter] and start the
Xmodem command
sequence in your
terminal emulator.
A-32

Copying Crash Data Content to a Destination Device

This command uses TFTP, USB, or Xmodem to copy the Crash Data content
to a destination device. You can copy individual slot information or the
management module's switch information. If you do not specify either, the
command defaults to the management function's data.
Syntax: copy crash-data [master>] tftp <ip-address> <filename>
copy crash-data [mm>] usb <filename>
copy crash-data [mm>] xmodem
where: mm
These commands copy the crash data content to a remote host,
attached USB device, or to a serially connected PC or UNIX
workstation. You can copy the management module (mm)
switch information. If you do not specify either, the command
defaults to the mm data.
For example, to copy the switch's crash data to a file in a PC:
Figure A-13. Example of Copying Switch Crash Data Content to a PC
Retrieves crash log or crash data from the switch's
chassis processor. When "mm" is specified,
crash files from both management modules are
copied.