HP PROCURVE 6120 Management And Configuration Manual page 224

ProCurve(config)# show interfaces brief
Status and Counters - Port Status
Port Type
----- --------- + --------- ------- ------ ----------
B1 100/1000T | No
B2 100/1000T | No
B3 100/1000T | No
B4 100/1000T | No
B5 100/1000T | No
B6 100/1000T | No
Figure 10-3. Example of Show Interfaces Brief Command Listing
| Intrusion
| Alert Enabled Status Mode
Yes
Yes
Yes
Yes
Yes
Yes
Use the show interfaces config command to view the port settings, as shown
below.
ProCurve(config)# show interfaces config
Port Settings
Port Type
----- --------- + ------- ------------ --------- ----
B1 100/1000T | Yes
B2 100/1000T | Yes
B3 100/1000T | Yes
B4 100/1000T | Yes
B5 100/1000T | Yes
B6 100/1000T | Yes
Figure 10-4. Example of a Show Interfaces Config Command Listing
The display option can be used to initiate the dynamic update of the show
interfaces command with the output being the same as the show interfaces
command. When using the display option in the CLI, the information stays on
the screen and is updated every 3 seconds, as occurs with the display using
the menu feature. The update is terminated with Cntl-C.
You can use the arrow keys to scroll through the screen when the output does
not fit in one screen.
Viewing Port Status and Configuring Port Parameters
Down Auto-10-100 Auto
Down 1000FDx
Down 1000FDx
Down 1000FDx
Down 1000FDx
Down 1000FDx
| Enabled Mode
Auto-10-100
Auto
Auto
Auto
Auto
Auto
Port Status and Configuration
MDI Flow Bcast
Mode Ctrl Limit
----- ----- ------
off 0
Auto off 0
Auto off 0
Auto off 0
Auto off 0
Auto off 0
Flow Ctrl MDI
Disable Auto
Disable Auto
Disable Auto
Disable Auto
Disable Auto
Disable Auto
10-9