HP PROCURVE 6120 Management And Configuration Manual page 157

Interface Access and System Information
Interface Access: Console/Serial Link, Web, and Inbound Telnet
7-6
Outbound Telnet to Another Device. This feature operates indepen-
dently of the telnet-server status and enables you to Telnet to another device
that has an IP address.
Syntax: telnet <ipv4-addr | ipv6-addr | hostname | switch-num> [oobm]
Initiates an outbound telnet session to another network
device. The destination can be specified as:
•
•
•
•
•
For example, if the host "Labswitch" is in the domain abc.com, you can enter
the following command and the destination is resolved to "Lab-
switch.abc.com".
ProCurve(config)# telnet Labswitch
You can also enter the full domain name in the command:
ProCurve(config)# telnet Labswitch.abc.com
You can use the show telnet command to display the resolved IP address.
IPv4 address
IPv6 address
Hostname
Stack number of a member switch (1-16) if the
switch is a commander in a stack and stacking is
enabled
The oobm parameter specifies that the Telnet
traffic will go out from the out-of-band manage-
ment interface. If this parameter is not specified,
the Telnet traffic goes out from the data interface.
Refer to Appendix G, "Network Out-of-Band
Management" in this guide for more information
on out-of-band management.