Menu: Configuring Ip Address, Gateway, And Time-To-Live (Ttl) - HP PROCURVE 6120 Management And Configuration Manual

N o t e s
For descriptions of these
parameters, see the
online Help for this
screen.
Before using the DHCP/
Bootp option, refer to
"DHCP/Bootp
Operation" on page 8-12.
Menu: Configuring IP Address, Gateway, and Time-To-
Live (TTL)
Do one of the following:
To manually enter an IP address, subnet mask, set the IP Config parameter
■
to Manual and then manually enter the IP address and subnet mask values
you want for the switch.
To use DHCP or Bootp, use the menu interface to ensure that the IP Config
■
parameter is set to DHCP/Bootp, then refer to "DHCP/Bootp Operation" on
page 8-12.
To Configure IP Addressing.
1. From the Main Menu, Select.
2. Switch Configuration ...
5. IP Configuration
If multiple VLANs are configured, a screen showing all VLANs appears instead
of the following screen.
The Menu interface displays the IP address for any VLAN. If you use the CLI
to configure the IP address on a VLAN, use the CLI show ip command to list
them. (Refer to "Viewing the Current IP Configuration" on page 8-6.)
Figure 8-1. Example of the IP Service Configuration Screen without Multiple
VLANs Configured
(for Edit).
2. Press
[E]
Configuring IP Addressing
IP Configuration
8-5