HP PROCURVE 6120 Management And Configuration Manual page 158

ProCurve(config)# show telnet
Telnet Activity
--------------------------------------------------------
Session : ** 1
Privilege: Manager
From : Console
To :
-------------------------------------------------------
Session : ** 2
Privilege: Manager
From : 12.13.14.10
To : 15.33.66.20
-------------------------------------------------------
Session : ** 3
Privilege: Operator
From : 2001:db7:5:0:203:4ff:fe0a:251
To : 2001:db7:5:0:203:4ff1:fddd:12
Figure 7-3. Example of show telnet Command Displaying Resolved IP Addresses
Reconfigure Web Browser Access. In the default configuration, web
browser access is enabled.
Syntax: [no] web-management [listen <oobm | data | both>]
Use the no
access.
The listen
separate out-of-band management port. Values for this
parameter are:
•
•
•
Refer to Appendix G, "Network Out-of-Band Management" in
this guide for more information on out-of-band management.
The
listen
have a separate out-of-band management port.
Interface Access and System Information
Interface Access: Console/Serial Link, Web, and Inbound Telnet
version of the command to disable inbound HTTP
parameter is available only on switches that have a
oobm — inbound HTTP access is enabled only on
the out-of-band management port.
— inbound HTTP access is enabled only on
data
the data ports.
both — inbound HTTP access is enabled on both
the out-of-band management port and on the data
ports. This is the default value.
parameter is not available on switches that do not
7-7