Copying Event Log Output To A Destination Device; Copying Crash Data Content To A Destination Device - HP 4108GL Management And Configuration Manual

Procurve switch
Table of Contents

Advertisement

Copying Event Log Output to a Destination Device

This command uses TFTP or Xmodem to copy the Event Log content to a PC
or UNIX workstation on the network.
Syntax:
For example, to copy the event log to a PC connected to the switch:
At this point, press
[Enter] and start the
Xmodem command
sequence in your
terminal emulator.
Figure A-8. Example of Sending Event Log Content to a File on an Attached PC

Copying Crash Data Content to a Destination Device

This command uses TFTP or Xmodem to copy the Crash Data content to a PC
or UNIX workstation on the network. You can copy individual slot information
or the master switch information. If you do not specify either, the command
defaults to the master data.
Syntax:
For example, to copy the switch's crash data to a file in a PC:
At this point, press
[Enter] and start the
Xmodem command
sequence in your
terminal emulator.
Figure A-9. Example of Copying Switch Crash Data Content to a PC
Copying Diagnostic Data to a Remote Host, PC, or Unix Workstation
copy event-log tftp <ip-address> <filepath and filename>
copy event-log xmodem
copy crash-data [<slot-id | master>] xmodem
copy crash-data [<slot-id | master>] tftp <ip-address> <filename>
where:
slot-id = a - h, and retrieves the crash log or crash data from
the processor on the module in the specified slot.
master
Retrieves crash log or crash data from the switch's
chassis processor.
File Transfers
A-17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents