HP PROCURVE 6120 Management And Configuration Manual page 201

Procurve series 6120 switches
Table of Contents

Advertisement

Time Protocols
SNTP: Viewing, Selecting, and Configuring
N o t e
9-12
second or third server, you must use the CLI. For more on SNTP operation
with multiple servers, refer to "SNTP Unicast Time Polling with Multiple SNTP
Servers" on page 9-25.
Syntax: timesync sntp
Selects SNTP as the time synchronization method.
Syntax: sntp unicast
Configures the SNTP mode for Unicast operation.
Syntax: sntp server <ip-addr> [version]
Specifies the SNTP server. Server version values are between
1 and 7. The default server version is 3
Syntax: sntp server priority <1 - 3 >
Specifies the order in which the configured SNTP servers are
polled for getting the time. Value is between 1 and 3.
Syntax: [no] sntp server priority <1-3> <ip-address> [oobm] [version]
Use the
no
priority
specifies the order in which the configured SNTP serv-
ers are polled for the time; allowable values are 1 through 3.
ip-address
For switches that have a separate out-of-band management
port,
oobm
(By default, SNTP traffic goes through the data ports.)
version
is the protocol version of the SNTP server. Allowable
values are 1 through 7; default is 3.
Syntax: no sntp server < ip-addr >
Deletes the specified SNTP server.
Deleting an SNTP server when only one is configured disables SNTP unicast
operation.
For example, to select SNTP and configure it with unicast mode and an SNTP
server at 10.28.227.141 with the default server version (3) and default poll
interval (720 seconds):
ProCurve(config)# timesync sntp
Selects SNTP.
version of the command to disable SNTP.
is an IPv4 or IPv6 address of an SNTP server.
specifies that SNTP traffic goes through that port.
.

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PROCURVE 6120 and is the answer not in the manual?

This manual is also suitable for:

Procurve 6120g/xgProcurve 6120xg

Table of Contents

Save PDF