HP PROCURVE 6120 Management And Configuration Manual page 202

Procurve series 6120 switches
Table of Contents

Advertisement

.
ProCurve(config)# show sntp
SNTP Configuration
Time Sync Mode: Sntp
SNTP Mode : Unicast
Poll Interval (sec) [720] : 720
Priority SNTP Server Address
-------- -------------------------------
1
2001:db8::215:60ff:fe79:8980
2
10.255.5.24
3
fe80::123%vlan10
Figure 9-8. Example of Configuring SNTP for Unicast Operation
Figure 9-9. Example of Specifying the SNTP Protocol Version Number
ProCurve(config)# sntp unicast
Activates SNTP in Unicast mode.
ProCurve(config)# sntp server 10.28.227.141
Specifies the SNTP server and accepts the current SNTP
server version (default: 3).
If the SNTP server you specify uses SNTP version 4 or later, use the sntp server
command to specify the correct version number. For example, suppose you
learned that SNTP version 4 was in use on the server you specified above (IP
address 10.28.227.141). You would use the following commands to delete the
server IP address and then re-enter it with the correct version number for that
server:
SNTP: Viewing, Selecting, and Configuring
In this example, the Poll Interval and the Protocol
Version appear at their default settings.
Both IPv4 and IPv6 addresses are displayed.
Note: Protocol Version appears only when there is an
IP address configured for an SNTP server.
OOBM
------------- ----------------
No
Yes
Yes
Deletes unicast SNTP server entry.
Re-enters the unicast server with a non-
default protocol version.
show sntp displays the result.
Time Protocols
Protocol Version
7
3
3
9-13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve 6120g/xgProcurve 6120xg

Table of Contents